Frost-Byte H2O Case and H2O Cooling System ReviewPosted on 2004-07-19 13:02:47 by LSDsmurf
Every good Water Cooled rig starts out with the pump, for this we are using the Danger Den 12V Pump which plugs into a standard molex connection and turns on and off with the PC. From here we move on to the reservoir which is a Floppy Bay Reservoir allowing you to fill the system with the twist of a cap. Next, we have mounted a Black Heater Core radiator in the top of the case with a low profile shroud which will give you some of the best temps possible from a water rig. Attached to the radiator is a 120mm Aluminum Fan pulling almost 90cfm's. Finally we run 1/2 inch PrimoFlex Tubing, all cut to perfect lengths, and clamp these puppies down with colored hose clamps.