Posted on Tuesday, August 25 2020 @ 14:23 CEST by Thomas De Maesschalck
ThermalTake surprises us with the release of a plain old fan. The new TOUGHFAN 12 High Static Pressure Radiator Fan is immediately available online via the firm's webshop for 22.32EUR. This 120mm PWM fan spins at 500 to 2000RPM, has a maximum airflow of 58.35CFM, a maximum static pressure of 2.41mm-H2O, and a maximum noise level of 22.3dBA.
The fan uses second-generation hydraulic bearing and is rated at 40,000 hours of operation.
Thermaltake, the leading PC DIY premium brand for Cooling, Gaming Gear, and Enthusiast Memory solutions, launches the TOUGHFAN 12 High Static Pressure Radiator Fan which is designed to achieve maximum static pressure and low noise signature for users that pursue high-end cooling. The TOUGHFAN fan is a PWM controlled fan designed to perform at a maximum operating speed of up to 2000 RPM and is optimized for high static pressure while maintaining minimal noise levels. The liquid crystal polymer (LCP) fan blades are extremely tensile in strength; its’ low thermal expansion coefficient can reduce the fan’s vibration when running at full speed. Other than that, the centerpiece of the TOUGHFAN 12’s motor hub is made of full steel, and the shaft is reinforced by copper housing, which not only secures the fan but further lowers the noise while the fan is in operation. The TOUGHFAN also incorporates a 2nd generation hydraulic bearing, which provides not only stability but helps the fan reach a longer lifespan. For users who are looking for a high-performance, low noise fan for their PC, the new TOUGHFAN 12 High Static Pressure Radiator Fan will be the perfect addition to their build.
Features of the TOUGHFAN 12 High Static Pressure Radiator Fan:
PWM Controlled Fans
PWM controlled fans allow the temperature sensor on the motherboard to send signals to the fans, allowing fan to ramp up when needed or slow down when necessary.
High Air Pressure and High Air Flow
TOUGHFAN 12 is designed with a static pressure of 2.41 mm-H2O and with an airflow of 58.35 CFM.
Optimized Gen.2 Hydraulic bearing
TOUGHFAN is equipped with an optimized second generation hydraulic bearing. The unique structural design of the hydraulic bearing stores the lubricant in tiny grooves of those easily abraded areas, which not only decreases friction significantly but achieves a longer lifespan.
Anti-Vibration Mounting System
The In-mold injection anti-vibration rubber pads dampen the vibration of the fan allowing the fan to spin at higher levels without compromising noise levels. The fan is designed with 80% coverage for all corners, maintaining low noise levels when in operation.
