Intel Pro/1000 6.2.15
Posted on Monday, October 17 2005 @ 23:38 CEST by LSDsmurfChangelog:
- Fixed the DRV_LOADED bit setting when disabling the net interface in Linux, AMT doesn't switch to active
- Fixed access to non-existent registers can cause kernel panic at worst and loss of functionality at best
- Fixed the e1000.spec file which contained no strings for PCI ID 1099
- Included Linux support for Kingsport II with Device ID 1099
- Fixed Tx Hang on 2.6.13 kernel with TSO on with Ophir
- Fixed different flow control defaults from other NICs
- Fixed the traffic stops during small packet stress w/napi disabled
- Fixed the fifo_error counts by not incrementing netdev->fifo_errors
- Fixed the driver which reads hardware stats even when down.
- Fixed the traffic stops during small packet stress w/napi disabled
- Added support for identifying eeprom image version in ethtool register dump
- Fixed compiling warnings and errors
- Set flow control watermarks relative to PBA size
- Fixed system panic with running ifconfig_tst under network stress
- Added memory allocation failures/tx_timeout counts to stats
- Corrected the incorrect id string for device id 1013 with subdevice 1013
- Removed non-intel sub-vendor ids from pci.updates
- Fixed kernel panic with bridging
- Fixed netdev errors under rx/tx stress
- Implement a workaround for premature Tx descriptor WB
- Fixed when the driver incorrectly detects hang during stress test on 10mb hub
- Fixed link loss caused by certain operations during SOL/IDER session
- Fixed autonegotiation which causes the link to drop on switches with Spanning Tree enabled, the link takes longer to recover.
- Cleared contents of buffer_info struct in clean_tx_irq
- Fixed the WOL status which was incorrect for the second port of dual port cards
- Fixed the failures in ethtool loopback diag
- Fixed the link loss caused by certain operations during SOL/IDER session
- Fixed the kernel panic with e1000-6.0.54 with 82573 with Knoppix 3.3
- Fixed the receive problem when MQ enabled
- Fixed a build problem when mq is enabled and napi is disabled
- Added support for a printout of the state of Multiqueue with the number of queues.
- Implemented a single buffer size using 2048 byte descriptors for all receive modes on non PCI Express hardware. Jumbo frames use an appropriate number of 2048 byte descriptors.
- Added statistics for Multiple Queues
- Corrected the make which returned warnings
- Fixed the adapter identification did not work as expected
- Fixed the WOL status reported by ethtool which did not match the EEPROM
|
Program Information Category: Drivers Type: Free Version: 6.2.15 Size: 159KB Works on: Linux Product page: here |
Loading Comments